Thermistor 100K, Crimped w/ Cables – UltiMachine

This thermistor is used for measuring the temperature of the RepRap extruder.  The thermistor has been crimped with wire leads and a 2-pin male latch housing. The matching cable has been housed with a 2-pin female latch housing on one end, and a 2-pin connector labeled "thermistor" on the other end. The default thermis

Thermistor 100K NTC B3950 M3 Screw-In Style

CHC Pro 115W NTC 100K B3950 Thermistor

New Pool 7790 15FT 10K Ohm Temperature Sensor Thermistor Solar Water Air with 15 Feet Cable for SPA Automation Control Systems - China 7790 15FT Glx-PC-12-Kit Ntctemperature Sensor, 7790 15 Feet Glx-PC-12-Kit

Model:HT-NTC100K thermistor temperature sensor componentsSpecifications:Negative Temperature Coefficient (NTC) Thermistor Model: B3950Temperature

NTC 100K B3950 Thermistor 300 Degrees

Thermistor 100K NTC B3950 M3 Screw-In Style

RAMPS 1.4/ua - RepRap

A custom made thermistor encapsulated into an easy to use cartridge package.This sensor are able to measure higher temperatures-upto 280degC. DIY

2-Pack NTC 100K B3950 Thermistor OD3mm Cartridge Sensor High Temperature 280℃ for Ender 3 V2 Pro CR10 V6 PT100 Heater Block 3D Printer

6*20mm 12V 40W 100K NTC Thermistor Wire 150mm PH2.0-2PIN Terminal for 3D Printer

Using 32-bit, 64 MHz MCUs STM32G0B1CBT6 from the industry leading ensures rock solid performance with CAN bus signaling that can support higher- data

EBB SB2209 CAN with Pre-Crimped 30-Pin Wire NTC100K Thermistor for Voron StealthBurner 3D Printer Hotend Klipper SB2240 EBB SB2209 CAN with

NTC 3950 Thermistor for 3D Printers - 100K Ohm 1 Meter Cable - With Socket

Electronics – Page 2 – UltiMachine

CHC Pro 115W NTC 100K B3950 Thermistor