Troubleshooting PETG First Layer - Overextrusion? – General discussion, announcements and releases – Prusa3D Forum

Hello, I've printed a ton of PLA since I've got my MK3S two years ago, but barely any PETG. I'm starting now, and I'm noticing some first layer issues

Error report: Cura software 4.10.0 - UltiMaker Cura - UltiMaker

Troubleshooting PETG First Layer - Overextrusion? – General

PETG inconsistently causing ruptures on surface of print

3D Printing Failures 2022 Edition How To Diagnose and Repair ALL

Sudden top layer problems – Hardware, firmware and software help

Help Fixing These First Layer Issues? – How do I print this

Applied Sciences, Free Full-Text

Applied Sciences, Free Full-Text

Error report: Cura software 4.10.0 - UltiMaker Cura - UltiMaker

Troubleshooting PETG First Layer - Overextrusion? – General

Myriad of First Layer Issues {MK3S+} : r/prusa

First Layer - LulzBot TAZ - LulzBot